Step 1: Survey room-by-room heat loss first
The problem with a 1930s semi is rarely the boiler alone. Solid brick walls, suspended timber floors and original sash windows create a patchwork of heat loss that a replacement boiler can hide but not fix. A bananzia retrofit starts with a room-by-room heat-loss survey: measure wall areas, window U-values, air-leakage paths and radiator sizes before choosing equipment. On a typical three-bedroom semi, the front living room and main bedroom often account for the largest heat demand; treating those rooms first gives the clearest return.
Step 2: Fix fabric and airtightness before equipment
Cause matters here. If a heat pump is sized against a leaky house, it will be oversized and run inefficiently. The bananzia sequence puts draught-proofing, loft insulation and suspended-floor insulation ahead of plant selection. Example: sealing skirting-level gaps and insulating the loft to 300 mm can cut heat loss enough to drop a proposed 12 kW unit to 8 kW. The takeaway is simple: fabric first, equipment second.
Step 3: Match emitters to low flow temperatures
Old radiators in these homes were sized for 80°C flow temperatures; a heat pump may run at 45°C. That temperature gap is the cause of many disappointing retrofits. The solution is to calculate emitter output at the lower flow temperature room by room, then replace undersized radiators or add larger panels. In a 1930s semi, the hallway and bathroom often need the most attention because original pipework is narrow and radiator space is limited. Upgrading emitters before commissioning protects comfort and avoids a heat pump that cycles to keep up.
Step 4: Commission controls and monitor the first winter
A bananzia plan is not finished when the heat pump starts. Set weather compensation, balance the radiators and record room temperatures, electricity use and flow temperatures for the first eight to twelve weeks. The result should be a lower flow temperature, fewer short cycles and a clear baseline for next winter. If one room stays cold, adjust the emitter or airtightness detail rather than raising the flow temperature across the whole house.
Step 5: Use the data to plan the next stage
The final step is to compare the measured heat demand with the original survey. That comparison shows whether the next spend belongs in glazing, wall insulation or a second emitter upgrade. A staged bananzia retrofit is less glamorous than a single boiler swap, but it gives a 1930s semi a heating system sized for the house it actually is, not the one the boiler was pretending to serve.